UV DTF 3D PermaStickers™ Application Instructions
Equipment Needed to Get Started:
- Squeegee
- UV DTF 3D PermaSticker™
- Hard Good / Surface to apply to
- Clean cloth (optional, for prepping the surface)
Step-By-Step Application Instructions
Follow these steps for a clean, durable UV DTF sticker application.
1. Prep the Surface & Pre-Squeegee
Make sure the application surface is clean and dry. Run a squeegee over the sticker carrier to flatten and secure the design before peeling.
2. Prepare the Transfer
Carefully peel apart the carrier sheets so the printed design stays attached to the top carrier, ready to place.
3. Place the Sticker
Position the design where you want it on the surface and press it down firmly, working from one edge across to remove any air pockets.
4. Squeegee & Peel the Carrier
Squeegee over the carrier to ensure the design is fully bonded, then slowly peel the carrier away at a low angle to leave the sticker in place.
Ready to Order?
Design your own UV DTF 3D PermaStickers™ in any shape or size.